![]() Actual power supply distance will vary as a result of 1) AP status, including transmit power, connected devices and network traffic along with 2) cable properties, including type and texture, and 3) environmental factors, which include temperature and humidity. *** Power supply distances are based on test results under normal usage conditions. Refer to the instruction manual and consult an IT professional to assist with setting up this product. ** Protection against lightning and electro-static discharge may be achieved through proper product setup, grounding and cable shielding. Actual wireless transmission rate, wireless coverage, and number of connected devices are not guaranteed, and will vary as a result of 1) environmental factors, including building materials, physical objects and obstacles, 2) network conditions, including local interference, volume and density of traffic, product location, network complexity, and network overhead and 3) client limitations, including rated performance, location, connection quality, and client condition. Range and coverage specifications along with the number of connected devices were defined according to test results under normal usage conditions. * Maximum wireless transmission rates are the physical rates derived from IEEE Standard 802.11 specifications. Operating Humidity: 10%~90% non-condensing Optimized IGMP Snooping/Proxy for multicast applicationsġ 10/100Mbps Shielded Ethernet Port (Power + Data)ġ 10/100Mbps Shielded Ethernet Port (Data) Monitors: Throughput/Stations/Interfaces/ARP/Routes/WAN/DHCP Signal Strength/Noise/Transmit CCQ/CPU/Memory > Threshold/DTIM Interval/AP Isolation/Short GI/Wi-Fi Multimediaĭiscovery and Remote Management via Pharos Control application > Beacon Interval/RTS Threshold/Fragmentation Multi-SSID with VLAN Tagging (AP mode only) The speed measurements were made with SpeedTest. We used both laptops in different apartments, with different wireless routers, in the rooms were we had the lowest speed on WiFi, in each of the two apartments. Security: WPA/WPA2, WPA-PSK/WPA2-PSK (AES/TKIP) Encryption, 64/128/152-bit WEP Encryption We first tested the wireless network speed with Throughput Booster disabled and Transmit Power set to Lowest. ![]() IEEE 802.11b/g/n (with Pharos MAXtream disabled) Note: When deployed using Passive PoE, the power drawn from the power source will be higher by some amount depending on the length of the connecting cable.īuilt-in 9dBi 2x2 Dual-polarized Directional Antennaīeam Width: 65° (H-Plane) / 35° (E-Plane) To provide strong WiFi outside for the outdoor cameras. Near Site WiFi Extension to the Outdoor Wireless Security Cameras (up to 100 meters or 300 feet) It’s hard for WiFi signals to penetrate wire-filled stucco walls or stone walls. Passive Power over Ethernet via LAN0 (+4,5pins -7,8pins) A network extension to the remote location farther than 300 feet will need a point-to-point wireless bridge. 1 10/100Mbps Shielded Ethernet Port (Passive PoE in) ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |